Burial Operations Support System
Monument Type - 'R2' (Reverse Inscription)


The Monument Application module will allow cemeteries the capability to Reverse Inscribe monuments locally. The required criteria is as follows:

  1. The veteran must predecease the spouse or dependent(s).
  2. The monument must be multiply inscribed.
  3. The veteran and spouse/dependent must share the same gravesite and monument.
  4. Prior decedent must be entered in BOSS.
  5. The monument type must be upright.
  6. The monument type must be 'R2' (Reverse Inscription).
  7. This capability only applies to initial monument applications, it cannot be used for replacement applications.

How to Process an 'R2'
Replacements

TOP

  • How to process the Monument Type - 'R2'
    In order for BOSS to recognize the predeceased decedent, the prior decedent sharing the same gravesite and monument must be entered in BOSS as a case. When preparing the Monument Application for the first decedent, BOSS will not allow you to enter 'R2' at that time. BOSS will insist on 'U1' until the second decedent's Monument Application is created. At this point, BOSS will allow 'R2' to be entered as a monument type. 'R2' at this time will be recognized for both decedents (prior and current) for the Monument Application.

     Inscription approve and release Marker to be Ordered?  

                                        (Yes) (No)

    TOP

  • Replacements
    When replacing an 'R2' monument, refresh the inscription on page 2 of the Format and Approve Monument Inscription screen. This procedure will ensure that any changes made to the inscription will be reflected on the new monument. If the inscription is not re-formatted, the old inscription will be sent to the vendor.
    See Replacement Monument Applications.

    *NOTE - You cannot replace an 'R2' as an 'R2', the replacement monument type must be 'U' or 'V'.
    Return to Monument Application.

    TOP